Incline Feature; 400 Metre Track; Pulse Grip Feature; Calorie Display - LifeSpan PERFORMER PLUS User Manual

the speed is above 3.6km/h, if under 3.6km/h, then it will stop immediately.
5. In the state of running, single press CLEAR will reset all number except the speed. Then
enter into manual mode.
6. To stop the tread-belt press and release the START/STOP.

4.5 Incline Feature

 Incline may be adjusted anytime after belt movement.
 The incline range is from 0 to 20.
 Press the 'up' or 'down' to achieve desired level of effort. Four Quick access key of 3, 6 and 9
are also available to adjust the incline percent.
 You can also adjust the incline percent by using the '+' or '-' on handrail.
 The display will indicate incline percent as adjustments are made.
 Incline will remain in its position when display is turned off.

4.6 400 Metre Track

The 400 Meters Track will be displayed on the simulation running track. The flashing dot
indicates your progress, but only to show an approximate speed of effort. Once the 400 meter is
complete, the buzzer will sound three times, this feature will begin again.

4.7 Pulse Grip Feature

The Pulse (Heart Rate) console window will display your current heart rate in beats per minute
during the workout. You must use both stainless steel sensors to display your pulse. Pulse value
displays anytime the upper display is receiving a Grip Pulse signal.

4.8 Calorie Display

Displays the cumulative calories burned at any given time during your workout.
Note: This is only a rough guide used for comparison of different exercise
sessions, which cannot be used for medical purposes.

4.9 Folding and Unfolding Treadmill:

4.9.1 Folding

First, lift the back part of the frame board with your hand till you hear a light sound, which
means the folding system has been locked. Running board can't be turned to the opposite
direction now.

4.9.2 Unfolding

LIFESPAN PERFORMER PLUS 9