Removing And Installing The Processor - EUROCOM P570WM Service Manual

Disassembly

Removing and Installing the Processor

Figure 11
Processor Removal
Processor Removal Procedure
1. Turn off the computer, and turn it over, remove the battery
a. Locate the heat sink.
2. The CPU heat sink will be visible at point
b. Remove the CPU fan ca-
3. Carefully disconnect CPU fan cables
bles and screws.
c. Remove the heat sink cated on the label
4. Carefully (it may be hot) lift up the heat sink
a.

Caution
The heat sink, and CPU
b.
area in general, con-
tains parts which are
subject to high temper-
atures. Allow the area
time to cool before re-
moving these parts.

9. CPU Heat Sink
• 6 Screws
2 - 16 Removing and Installing the Processor
(Figure 11b) and carefully pull the tabs
A
4
8
7
1
Note: make sure not to trap or catch the plastic heat
sink tab while removing or tighting the srew
8
(page 2 - 5), and component bay cover
on the mainboard.
A
- , and remove screws ,
B C 6
- to disconnect the heat sink.
7 8
off the computer.
9
c.
3
2
5
B
6
C
.
4
(page 2 -
, , , , , the reverse order indi-
5 4 3 2 1
9
10).