Removing And Installing The Processor; Processor Removal Procedure - EUROCOM W880CU Service Manual

Disassembly

Removing and Installing the Processor

Figure 16
Processor

Processor Removal Procedure

Removal
1. Turn off the computer, remove the battery
Procedure
video card heatsink
2. Remove screws
a. Remove the screws
1 last)
in the reverse order.
b. Carefully remove 3. Carefully (it may be hot) remove the heat sink unit
the heat sink unit by
pulling the label up.
a.

CPU Warning
In order to prevent
damaging the contact
pins when removing
the CPU, it is neces-
sary to first remove the
WLAN module from
the computer.
Note: Loosen the screws in the reverse order
4-3-2-1 as indicated on the label.

5. Heat Sink Unit
• 4 Screws
2 - 20 Removing and Installing the Processor
(page 2 - 17).
- from the heat sink unit in the order indicated on the label (i.e screw 4 first through to screw
1 4
(Figure 16a ).
4
1
3
2
(page 2 - 5), component bay cover
by pulling the label up
5
b.
(page 2 - 10), fans (page 2 - 17) and
(Figure 16b ).
)
5