Installing The Vga Card - EUROCOM P570WM Service Manual

Installing the VGA Card

1. Do not forget to replace the master and slave cable if you are replacing two video cards.
2. Prepare to fit the VGA card
1
3. The card needs to be fully into the slot, and the VGA card and socket have a guide-key and pin which align to allow
the card to fit securely.
4. Fit the connectors firmly into the socket, straight and evenly.
5. DO NOT attempt to push one end of the card in ahead of the other.
6. The card's pin alignment will allow it to only fit one way. Make sure the module is seated as far into the socket
as it will go (none of the gold colored contact should be showing). DO NOT FORCE the card; it should fit without
much pressure.
7. Secure the card with screws
8. Hold the heatsink by the tab
order indicated in (page 2 - 19).
9. Attach the VGA card fan, secure with the screws and reconnect the fan cable as indicated in
10. Reinsert the component bay cover, and secure with the screws as indicated in
a.
1
into the slot by holding it at about a 30° angle.
& and mylar covers (two video cards are pictured).
2 3 4
& and at point and insert it back on the card and secure the screws in the
5 6 7
(page 2 - 19).
(page 2 - 14).
b.
4
4
2 2
3 3
c.
5
4
6
7
6
5
Disassembly
Figure 16
VGA Card
Installation
a. Carefully Insert the VGA
Card.
b. Tighten the screws.
c. Press the VGA heat
sink.

1. VGA card Module
4. VGA mylar covers
Removing the VGA Card 2 - 21