Maintenance; Removing The Front Dust Filter - Barco DP2K-12C Installation Manual

11. MAINTENANCE

About this chapter
This chapter describes how to remove the dust filters
Overview
• Removing the front dust filter
• Clean the dust filter on the bottom side
• Clean the dust filter on the top side
• Cleaning the lens
• Cleaning the exterior of the projector
• Check cooling liquid level
• Cleaning the UV blocker of the Lamp House
• Authorization to clear security warning on the projector
The air filters should be cleaned monthly under normal environment conditions. Equipment in very dusty or
otherwise contaminated areas may require more frequent maintenance.
If the air filters are not regularly cleaned, the air flow inside the projector could be disrupted and cause over-
heating. Overheating may lead to the projector shutting down during operation.
11.1 Removing the front dust filter
The front filter of the projector can be removed from the lamp side.
The filter can be cleaned.
Remove the dust filter
1. Remove the input cover of the projector, "Removal of the input cover", page 68.
2. Release the captive screw of the front cover.
Pull the left side of the front cover 5 centimeters forwards. There is no need to remove the cover completely.
R5905050 DP2K C-SERIES 10/07/2012
11. Maintenance
79