Removal Of The - Barco DP2K-12C Installation Manual

Image 10-4
Remove input cover
10.3 Removal of the front cover
The input cover and the lens have to be removed before removing the front cover. See procedures "Removal
of the input cover", page 68, and "Lens removal", page 39.
Necessary tools
Flat screw driver
How to remove the front cover of the projector
1. Check if the input cover and the lens are removed.
2. Remove the rubber dust ring from the lens holder. See the detail at the right side of image 10-5.
3. Release the captive screw at the middle bottom of the front cover, using a flat screw driver.
Image 10-5
Release front cover
4. Remove the front cover from the projector doing the following:
a) standing in front of the projector, pull the upper right corner (A) of the front cover toward you until the latch releases,
b) pull the lower right corner (B) of the front cover toward you until the latch releases,
c) then move the front cover away from the projector.
R5905050 DP2K C-SERIES 10/07/2012
B
A
10. Removal and installation of projector covers
C
69