Necessary parts
•
Two cable ties.
•
Certified AC power supply cord 4.0 mm², 10AWG, min. 300V.
How to connect the main AC power with the DP2K C-series projector projector?
1. Remove the rear cover and lamp cover of the projector.
2. Remove the cover of the main AC compartment by releasing the three captive thumb screws.
Image 3-6
3. Guide the AC power cord through the cable gland and connect the wires to the 3-terminal strip as illustrated.
Warning:
Always connect first the PE wire.
Image 3-7
4. Secure the power cord with the chassis of the projector by using two cable ties (A) and by fastening the cable gland (B) as
illustrated.
Use the appropriate screws, depending on the diameter of the cable (two sets of screws are delivered with the projector in a
separate bag). Turn in both screws so that the end of the screws are far enough in the plastic part and that the feet of that part
grip in the chassis. Check the fixation by pulling on the gland.
R5905050 DP2K C-SERIES 10/07/2012
PE
3. Physical installation
17