Table of Contents
Advertisement
Input Configuration
Within this menu, the inputs can be configured. Each input has different settings
depending on the signal format. Consult the tables below for signal formats per input and
possible adjustments per signal format.
To configure inputs:
1.
From the top level Input Configuration menu, press the Next button to bring up the
input selection screen. The active input is displayed on the LCD with current signal
format.
NOTE: If the input shown is not the one to be adjusted, press the desired input
button.
2.
With the correct input displayed, rotate the right Adjust knob ([{) to change the
signal format (refer to table below for signal type per input).
Input 1
*Auto Detect
RGB
Auto YUV
RGBcvS
S-video
Composite
Figure 9.
3.
Press the Next button to go to the next setting. If necessary, repeat pressing Next
until the desired level is attained. Refer to the table below for adjustable settings for
each signal format.
Input Format
RGB
Film Detect
X
H Start
X
V Start
X
Phase
X
Total Pixels
X
Active Pixels
X
Active Lines
X
EDID
X
Figure 10.
4.
At the desired setting (for example, Horizontal and Vertical Start on
input 1 with a YUVp/HDTV signal, see image at right), rotate both
Adjust knobs ([{) to adjust the settings value as desired (here at
128).
5.
Repeat steps 3 and 4 for each setting as desired.
6.
When complete, press Menu once or Next repeatedly to return
to the top level menu. Alternatively, allow the unit to time out to return to the default
cycle.
Input 2
Input 3
*HDMI/DVI
*DisplayPort
Signal Formats per Input (*= Default Value)
YUVp/
YUVi
RGBcvS
HDTV
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Adjustments Possible per Signal Format
S-vid
Composite DVI
HDMI
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Annotator 300 • Operation
DisplayPort
X
X
1: H
Start
V
128
128
18
Advertisement
Table of Contents
