Setting The Front Panel Locks (Executive Modes); Enabling Or Disabling Executive Mode 2 From The Front Panel - Extron electronics Annotator 300 User Manual

Setting the Front Panel Locks (Executive Modes)

The Annotator 300 has two levels of front panel security lock that limit the operation
of the device from the front panel.
Executive mode 0 (disabled) — The front panel is fully unlocked. This is the default
setting.
Executive mode 1 (enabled) — The front panel is completely locked. This mode can
only be enabled and disabled using SIS commands. See the
Control" section from page 31 onwards, for further details.
Executive mode 2 (enabled) — The front panel is locked except for input switching and
Auto Image.

Enabling or Disabling Executive Mode 2 from the Front Panel

Press and hold the Menu and Next buttons to enable or disable the Executive Mode.
Figure 15.
When either Executive mode is enabled and a front panel action is attempted (other than
input switching and Auto Image), the LCD displays the status for 2 seconds.
Executive mode 2 can also be enabled or disabled by SIS commands. See the
Communication and
NOTES:
• If the Annotator 300 is in Executive mode 0 (unlocked), this procedure
enables mode 2 (locked).
• If it is in Executive mode 2, this procedure enables mode 0 (unlocks the unit).
MENU
Press and
LCD screen
hold for about
displays either
2 seconds.
NEXT
Turning Executive Mode On or Off
Control" section, for SIS commands.
"SIS Communication and
Executive Mode 2
Enabled
OR
Executive Mode
Disabled
Annotator 300 • Operation
"SIS
24