Table of Contents
Advertisement
Operation
This section of the manual discusses the operation of an Annotator 300 unit and is divided
into four sections:
•
•
•
Front Panel Overview
CAPTURE
1
USB
CONFIG
RECALL
A
B C
Figure 6.
A
B
C E
D
F
G
H
Front Panel Overview
The Annotator 300 Menu System
Setting the Front Panel Locks (Executive Modes)
AUTO
INPUTS
IMAGE
2
3
D
E
F
Front Panel Features
Front panel configuration port — Connect a control system or computer to
this mini USB port using an optional USB A Male to USB Mini B Male
Configuration Cable. This port is used for unit configuration and
firmware upgrades.
Front panel USB port — Connect an external drive to store or recall captured
images, or connect a user interface device to this port.
Special function buttons — These three buttons are:
•
Capture — Allows the capture and saving of the current image,.
•
Recall — Allows the user to recall a saved image.
Auto Image — Initiates auto image adjustment on the selected input.
•
Input buttons and LEDs — These three buttons are used to select and switch
inputs. A lit LED indicates the currently active input.
LCD display — This LCD screen displays two rows of menu, control response,
and configuration text.
Menu navigation buttons — These two buttons give access to menu
"The Annotator 300 Menu
commands. See
•
Menu button — This button gives direct access to a series of five menus.
•
Next button — This button allows page changes within each one of the
menus, and to exit the menu cycle.
Adjustment knobs — These two knobs are used with the menu navigation
buttons to adjust settings.
MENU
ADJUST
NEXT
G
H
System" section in this chapter.
Annotator 300 • Operation
ANNOTATOR 300
ANNOTATION GRAPHICS PROCESSOR
14
Advertisement
Table of Contents
