Table of Contents
Advertisement
On a Call Menu
While you are on a call, you can press flash (flash the switch hook) to enter and
exit the On a Call Menu, which allows access to the features described below.
While in the On a Call Menu, the caller cannot hear you and you cannot hear the
caller. If you hang up, your telephone will ring, and when you answer, you will be
connected to the call you were on before entering the On a Call Menu.
The exception to this rule is when a call waiting call comes in. In that case,
flashing the switch hook will bypass the On a Call Menu and connect you
immediately to the waiting call.
Dialing an Extension
To dial a contact's
extension
number,
flash
the switch hook and then press #. Tel-Lynx will dial the
extension you set for that contact.
Rotary Dialing: flash, 3, double flash
Navigate Phone Tree Mode
If you have problems navigating a phone tree while on a call, it may be that the
touch tones generated by your telephone are not being received cleanly by the
phone tree system. Press and hold # for at least one second to enter
Navigate Phone Tree mode. Now, when you press touch tones on your
telephone, Tel-Lynx will intercept and regenerate them in a way that they should
be received more cleanly by the phone tree system.
You must exit Phone Tree Navigate mode in order for the called party to be able
to hear you. To exit the Navigate Phone Tree mode, flash the switch hook.
Rotary Dialing: No equivalent function. Phone Tree Navigate mode is not
useful for rotary dial phones since Tel-Lynx already generates as clean a touch
tone signal as can be generated for the digits you dial.
Call Hold and Pick Up
The hold feature has several uses. You may want to place a call on hold to
switch telephones, to answer another line, or to start a conference call.
While you are on a call, you can place the call on hold, hang up the telephone,
and pick up the call from your current location or from any other telephone or
networked PC in your house that is connected to Tel-Lynx (see
from an Outside
Line).
To start a conference call, you will place the current call on hold, then place a
new call, place the new call on hold, and then join both held calls into a
Copyright 2013-2015, nVideon, Inc. Atlanta, GA All Rights Reserved Worldwide
Preliminary
once you are connected to the contact's main
Picking up a Call
Page 38 of 76
Advertisement
Table of Contents
