Circulation Motor / Pump (3,000 Series) - Asko 3,000 Series Training Manual

Circulation Motor / Pump (3,000 series)

The circulation pump & capacitor are accessed from the rear by removing the rear lower panel.
Before beginning always drain all water from the sump and disconnect power to the unit
Remove four T-15 Torx screws securing the lower rear panel.
Carefully pull top of panel out first, then release the tab from the slot in the base of the unit.
Screws
The circulation Motor has a resistance of 22 ohms and an attached 16 micro farad capacitor.
The motor uses 95 watts of power when operating.
Screws
22