Installation; Edid Configuration; Distance Calibration - Binary B-320-HDMATRIX-RCV-W Owner's Manual

Single cat5e/6 3d extender
Table of Contents

Advertisement

6. INSTALLATION

Note: Do Not connect power to the B-320-HDMATRIX-RCV-W until all other connections are made
and the unit is installed.
1. Run the cabling in the wall from the head end:
HD Matrix Link Cable:
Remote Power (Optional):
2. Connect the cables from the wall to the B-320-HDMATRIX-RCV-W.
3. Install the B-320-HDMATRIX-RCV-W into the junction box mounted in the wall.
4. Connect an IR Flasher and/or IR receiver being used.
5. Connect an HDMI cable from the B-320-HDMATRIX-RCV-W to the display.
6. Connect the 5V DC 2A Power Supply to the Latch-Locking Power Jack if remote power is not
being used.
7. Set the Distance Control rotary switch to 7 (Weakest).
8. Plug the local or remote power supply into an AC outlet.
9. Calibrate for distance. See 6.2 Distance Calibration for details.

6.1. EDID CONFIGURATION

EDIDs are stored in the HD Matrix; refer to the manual for the HD Matrix that is being used on
how to setup EDIDs.

6.2. DISTANCE CALIBRATION

CAUTION: Inappropriate signal level setting may cause an overpowering issue that may
shorten the product life. Follow the steps below to adjust the distance setting in order to
avoid overdriving.
1. Set the distance control to 7 (Weakest).
2. Select a source that is outputting the highest-quality video that will be transmitted to
the receiver.
A.
If you see flickering or blinking images on the display:
A.1 - Adjust the signal level from 7 to 0 one step at a time, and stop turning the
rotary switch when the audio/ video is playing normally.
© 2012 Binary
ShieldedCat5e/Cat6
(See above)
B-320-HDMATRIX-RCV-W Installation and Users Manual
pg.11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B-320-HDMATRIX-RCV-W and is the answer not in the manual?

Table of Contents