Changing Rotating Gobos - GLP impression spot one Instruction Manual

structured surface towards the LED light source and the flat side
towards the front lens.

4.1.2 Changing rotating gobos

1) Open the fixture, using the quarter turn screws on the top cover.
2) Press the gobo holder at the outer part of the wheel carefully out of
the hub. Pull it softly out of the central spring holder jig.
3) Now the gobo itself can be exchanged inside the gobo holder.
Remove the concentric spring with a small screwdriver or gripping
pliers. Change the gobo and put the spring in again.
4) Place the gobo holder back into the central spring holder jig in the
middle of the gobo wheel and snap it into place. You can open the
central spring holder with a bent screwdriver through a hole from the
opposite side of the wheel.
5) Push the gobo holder in the dedicated hub.
Attention: There must be no gap between the gobo holder and the
wheel afterwards. Check for a tight fit.
GLP German Light Products GmbH
(Instruction version 1.93) / from software version 1.52
22