Frymaster H14 Series Installation & Operation Manual page 46

Troubleshooting The Built-in Filtration System (cont.)
PUMP STARTS, BUT
NO TRANSFER TAKES
PLACE OR TRANSFER
IS VERY SLOW.
Is pumping erratic
(spitting/spurting)?
Move filter handle to OFF position. Allow oil/
shortening to cool, then empty pan. For Filter
Magic and FootPrint III units, verify that O-ring
on pan outlet is present and in good condition.
Verify that the O-ring on the oil return fitting at
the inside rear of the cabinet is present and in
good condition. Verify that filter paper and
screen have been properly installed and are
clean. Refill the filter pan and move filter handle
to the ON position.
Yes
being returned to the
Probable cause is solidified oil/
shortening in the filtration unit
Problem
return lines. Move filter handle to
resolved.
the OFF position, refill filter pan,
wait 10 minutes, then move filter
handle to ON position.
Yes
being returned to the
Probable causes are solidified oil/shortening in filtration
unit return lines or blockage of return line suction tube on
bottom of filter pan. A blockage of the return-line
suction-tube is usually due to sediment/food particle
build-up caused by failure to use crumb tray, and the use
of improperly sized or installed filter paper. Failure of
solidified oil/shortening in the return lines to melt
indicates a defective heater tape or 24 volt transformer.
No
Yes
Is oil/shortening
frypot?
No
Is oil/shortening
frypot?
No
If unable to clear
blockages, call
FASC.
Move the filter handle to the OFF
position. Allow oil/shortening to
cool, then empty the filter pan.
Verify that the Power Shower is
installed, if so equipped. Move the
filter handle to the ON position.
Probable cause is
Yes
improperly installed/
prepared filter pan
components.
6-7
Is a strong
stream of air being
pumped out of Power Shower
port (or rear flush port, if so
equipped)?
No