Frymaster H14 Series Installation & Operation Manual page 14

3. If shake time is programmed, you will be notified to shake the product "X" seconds after the
cook cycle begins (X= amount of time programmed). An alarm will sound and the display
will read SH_. The blank will be the switch number. If no shake time is programmed,
SH_ will not appear during the cook cycle.
4. At the end of cooking cycle, an alarm will sound; COOC will be displayed and the
associated product switch indicator will flash. To cancel the cook alarm, press the flashing
product switch.
5. At this time, the hold time will be displayed (if programmed greater than 0) and countdown
will begin. When the hold time counter reaches 0, an alarm will sound and Hd_ is
displayed. The blank will be the switch number. The hold alarm is canceled by pushing the
switch. If display is in use, hold time will count down invisibly until display is free.
3.1.2 Checking Temperature
A. Check the cooking oil/shortening temperature at any time by pressing the
the setpoint by pressing the
B. During the idle periods, when the fryer is on but not in use, "----" should appear on both
displays on a single frypot computer. "----" will appear on the display of the side that is turned
on in a dual pot computer. If not, check actual temperature and setpoint.
C. If you suspect a defective probe, check the cooking oil/shortening temperature with a
thermometer. Verify that the computer readout is reasonably close to your measured reading.
NOTE: The electronic circuitry can be affected adversely by current fluctuations and electrical
storms. If for no apparent reason the computer does not function or program properly, reset the
computer by unplugging the power cord and plugging it back in.
3.2 Programming The Computer Magic III
3.2.1 Full-pot
1. Activate the computer by pressing either
2. To enter the program mode, first press the
you have pressed this switch in error and do not wish to program, press the
Note: The computer will flash BUSY if cooking is in progress.
3. Press 1,6,5,0 in that sequence to enter the program mode.
switch twice.
switch.
switch. CODE will appear in the left display. If
3–4
switch once. Check
switch again.