Barco FL40 Quick Manual

Hide thumbs Also See for FL40:

Download this manual

Barco FL40 projector quick guide

Turning on

Press buttons (P1) or (R1) indicated in images above. The projectors power button will start blinking

blue light. The power on sequence might take a minute or two. When the light is constantly showing

blue, the projector is on.

IF THE PROJECTOR POWER WAS COMPLETELY OFF (ELECTRIC CORD NOT CONNECTED), READ THE

MANUAL SECTION 5.2.

Turning off

Press buttons (P1) or the "O" button right next to (R1) indicated in images above. Keep the button

pressed for approximately 4 or 5 seconds. During this time in the LCD screen of the projector a

power-down image is shown indicating the time how long to continue pressing the button should be

still continued. When the projector is powered down and cooling down, the light on the power

button (P1) will first blink white and then turn constantly white.

IF IT IS NECESSARY TO REMOVE THE POWER CORD OF THE PROJECTOR FOR SOME REASON

(NORMALLY THIS IS NOT AT ALL NECESSARY), DO NOT REMOVE THE POWER CORD OR TURN OFF

ELECTRICITY BEFORE THE PROJECTOR HAS BEEN POWERED DOWN FOR A COUPLE OF MINUTES!!

Page 1 Barco FL40 projector quick guide Turning on Press buttons (P1) or (R1) indicated in images above. The projectors power button will start blinking blue light. The power on sequence might take a minute or two. When the light is constantly showing blue, the projector is on.
Page 2 Changing projector source Changing the projectors source from for example DVI to HDMI or back, you have to use the remote control to do that. Press “Input” and select your source with the remote’s selection buttons. The source indicator in the lower corner of the screen should disappear shortly when you have your source showing something (for example the DVD player is on).