Removal Of The Input & Communication Unit - Barco FLM HD18 User Manual
Hide thumbs
Also See for FLM HD18:
- Brochure & specs (4 pages) ,
- User manual (239 pages) ,
- Service manual (331 pages)
Table of Contents
Advertisement
16. Servicing
Image 16-2
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
16.2 Removal of the input & communication unit
W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the input & communication unit from the projector ?
1. Switch off the projector and unplug the power cord at the projector side. See procedure "Switching off", page 45.
2. Ensure that no cables are connected to one of the ports of the input & communication unit.
3. Remove the input cover, see "Removal of the input cover", page 157.
4. Release the four captive screws in the corners of the input and communication unit as illustrated.
Image 16-3
5. Pull the input & communication unit out of its compartment, using the side handles provided.
148
:
This procedure may only be performed by qualified technical service personnel.
R5976986 FLM HD18 01/09/2006
Advertisement
Table of Contents
