Servicing; Removal Of The Lamp House - Barco FLM HD18 User Manual

16. SERVICING

About this chapter
This chapter contains general servicing procedures like lamp replacement, input unit replacement etc. Note that some of these
procedures may only be performed by qualified technical service personnel.
Overview
•

Removal of the lamp house

• Removal of the input & communication unit
• Removal of an input module
• Installation of the lamp house
• Installation of the input & communication unit
• Installation of an input module
• Realignment of the lamp in its reflector
16.1 Removal of the lamp house
W
ARNING
C
AUTION
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly handled.
Necessary tools
7 mm flat screw driver.
How to remove the lamp house of the projector ?
1. Switch off the projector and unplug the power cord at the projector side. See procedure "Switching off", page 45.
2. Remove the lamp cover, see "Removal of the lamp cover", page 157.
3. Release the three spring lock screws of the lamp house as illustrated.
Image 16-1
4. Clasp the lamp house by the handles and pull the lamp house out of the projector.
R5976986 FLM HD18 01/09/2006
:
This procedure may only be performed by qualified technical service personnel.
:
Never attempt to disassemble the lamp from its housing or to dispose of it. Return it to Barco.
16. Servicing
147