Replacing Major Components; Brewer - VKI Technologies 2001 Operation And Service Manual

SUPREMA 2001 - OPERATION & SERVICE MANUAL

REPLACING MAJOR COMPONENTS

REMOVING THE BREWER
INSTALLING THE BREWER
Page 42 of 60
1. Press the red "
OPEN BREWER
a) The brewer motor will cycle and stop with the chamber in the open
position.
2. Release the brewer lock pin.
a) Lower the lock pin by pulling it down all the way.
b) Turn the pin to the left until it is directly below
the flange, and release.
3. Remove the brewer from the brewer bracket.
a) Gently grasp the brewer with one hand on the top,
and the other hand on the bottom.
b) Pull the brewer towards you until it is free from
the bracket.
1. Press the red "
OPEN BREWER
a) The brewer motor will cycle and stop in a position where it will accept the
brewer with the chamber open.
2. Place the brewer onto the brewer bracket.
a) Make sure that the brew chamber is open.
b) Gently grasp the brewer, with one hand on the top, and the other hand on
the bottom.
c) Align the top edge of the brewer with the locating flanges on the brewer
bracket. One flange is at the left side of the bracket and the other is at the
back of the bracket.
d) Push the brewer into place to engage the brewer drive pin with the slot in
the motor coupling. If it does not align, move the brewer crank arm
slightly until you feel the brewer engaging with the motor coupling.
3. Engage the lock pin.
a) Release the lock pin from under the front flange and engage it with the
hole located on the front left side of the brewer. The brewer should now
be firmly in place.
July 6, 2001
" button.
" button.
Suprema 2001 - Operation & Service
Brewer lock pin