Regulations; General; Standards; Remeha Factory Test - REMEHA GAS 210-80 ECO PRO Technical Information

13. Regulations

13. Regulations

13.1 General

13.2 Standards

58
The Remeha Gas 210 ECO PRO is a high efficiency, floor stand-
ing central heating boiler, suitable for use with all types of natural
gas; it recovers both perceptible and latent heat from flue gases.
The units are inspected on the basis of the essential requirements
in the following directives:
- Gas Appliances Directive
- Efficiency Requirements Directive no. 92/42/EEC
- EMC Directive
- Low Voltage Directive
- Pressure Equipment Directive
CE identification number: 0085BS0132
NOx class: 5
NOx identification number: BS004
The following instructions must be adhered to when the Remeha
Gas 210 ECO PRO is installed:
- Gas Safety (Installation and Use) Regulations 1998 (as amended).
In addition to the above regulations, this boiler must be installed
in compliance with:
- Current I.E.E. Regulations for electrical installations
- Local building regulations
- The Building Standards (Scotland)
- (Consolidation) Regulations
- by-laws of the local water undertaking
- Health and Safety Document No 635 'The Electricity at W ork
Regulations 1989'.
It should also be in accordance with the relevant recommendations
in the current edition of the following British Standards and Codes
of Practice, viz. BS 6644, BS 5978 Part 1 & 2, BS 5449, BS 5446,
BS 6798, BS 6891 and BG DM2.

13.3 Remeha factory test

Before leaving the factory, every Remeha boiler is optimally set
and tested for:
- electrical safety;
- CO adjustment;
2
- hot water operation;
- water tightness;
- gas tightness;
- control unit parameters.
GAS 210 ECO PRO
no. 90/396/EEC
no. 89/336/EEC
no. 73/23/EEC
no. 97/23/EEC, article 3, sub. 3
114494-190310