Control Stops And Faults; General; Control Stop Codes - REMEHA GAS 210-80 ECO PRO Technical Information

GAS 210 ECO PRO

11. Control stops and faults

11.1 General

11.2 Control stops and faults

11.3 Control stop codes

114494-190310
The boiler is fitted with an advanced control unit. The heart of the
control is a microprocessor, the abc
controls the boiler.
Control stop:
The control stop is a (temporary) boiler operating mode due to an
abnormal situation. The boiler switches to the neutral position so
that it can return to a normal state. The display then shows the
shutdown status (with code 9) again. The boiler control unit will, at
first, try several times to start the boiler again. The boiler shall oper-
ate again when the causes of the control stop have been removed.
Fault:
If the shutdown condition still exists even after various automatic
control unit start attempts have been made or if a non-reproduc-
ible phenomenon has arisen, the boiler switches to fault mode
(also known as lock-out). The boiler can only resume operation
if the cause of the fault is rectified and the ' RESET button' is
pressed
The boiler display will show code 9.
The control stop codes can be read out as follows:
• Push the - key, and then the - key;
• The display shows ˜˜  = 9;
• Push the [+]- key one time; the display shows 5u and the
control stop code.

The boiler shall start automatically when the causes of the control
stop have been removed.
, which both protects and
®
11. Faults
49