Changing Parameters At User Level (Without Access Code); Changing Parameters At Service Level (With Access Code) - REMEHA GAS 210-80 ECO PRO Technical Information

GAS 210 ECO PRO
2x
2x
fig. 19 Changing parameters
114494-190310
9.1.5 Changing parameters at user level (without
The following settings can be changed at user level:
p1 = Flow temperature set point [°C], adjustable between 20
p2 = Pump post-circulation time 0..98 mins, 99 is continuous;
p3 = Boiler control; central heating on/off.
p4 = Display options
* Consult our Technical department for further information and
demands on the system.
The parameters can be changed at user level as follows:
1. Press the  -key several times until the  ˜ s ymbol flashes in the
2. Select the users menu using the  -key, p1 appears (the
3. Press the [+]-key; p2 appears (the 2 flashes);
3. Press the  ˜ - key again; 3 (min) appears and flashes: (fac-
114492LTAL21H021b
tory setting);
4. Change the value by pressing the [-] -key or the [+] -key, in this
5. Confirm the value with the ˜ -key, p2 appears (the 2 flashes);
6. Press

The p1 to p4 settings can be changed in the same way as
p2.
9.1.6 Changing parameters at service level (with
access
To prevent undesired settings, some parameter settings can only
be changed after the special access code 12 is entered. This
code may only be used by qualified installers.
The following settings can be changed at user and service levels:
access code)
and 90°C;
0 = Central heating
1 = Central heating
0 = Simple display
1 = Comprehensive display
2 = Display automatically goes to simple after three
minutes (factory setting)
menu bar;
1 flashes);
case for example to 15 min, with the [+] -key;
-
t he key twice, the boiler enters the current operating
˜
status.
code)
off
(= factory setting)
on
9. Commissioning
35