Removing a fan
block from the
C1200
Installing a fan
block in the C1200
84
Individual chassis fans cannot be removed and replaced in the chassis fan block
of the C1200; the entire fan block must be removed and replaced.
To remove a chassis fan block from the C1200, complete the following steps,
using the figure in
"Removing a chassis fan from the
reference.
.
Step
Action
1
Open the appliance, as described in
page 65.
2
Remove the "L" shaped air baffle by pulling up and lifting out.
3
Unplug the fan power cable from the motherboard.
4
Press the tab on the end of the fan block to release it from the chassis
slot.
5
Lift the fan block from the chassis.
To install a chassis fan block in the C1200, complete the following steps.
Step
Action
1
Slide the "L" shaped foot on the fan block into the chassis slot near
the chassis sidewall.
2
Lower the fan block to the chassis floor. Ensure that it is seated
between the raised guides and not on top of them.
3
Press down on the opposite end of the fan block until the tab fits into
the chassis slot.
4
Plug the power cable into the system fan connector on the
motherboard.
5
Install the air baffle.
6
Close the appliance, as described in
page 66.
C2100" on page 82 for
"Opening the
appliance" on
"Closing the
appliance" on
Replacing the fans