Network Appliance C1200 NetCache Service Manual page 20

10
Step Action
5 Align the back of the slide rails with the small brackets attached to
the equipment rack, then carefully slide the appliance into place and
tighten the screws on the two small brackets into the posts.
6
If you are mounting the
appliance as a...
Flush-mount
Mid-mount
7 Connect the appliance to the network and ASCII terminal, as
described in Chapter 3,
page 11.
Then...
Secure the appliance to the rack
posts by inserting the appropriate
screws (two for the C1200 and
four for the C2100) through the
holes in the left and right
mounting handles and slide rail
ears.
Note
After tightening the brackets on
your C1200, the chassis might
sag slightly. To keep the chassis
from sagging, loosen all
mounting screws slightly and lift
up the rear of the chassis until it
is level. While holding the
chassis level, retighten all the
bracket screws.
Secure the left and right slide rail
ears to their respective posts
using two M5 screws.
"Connecting the NetCache
Installing in a two-post equipment rack
appliance," on