Network Appliance C1200 NetCache Service Manual page 81

Installing a disk in a
single-disk C1200
Chapter 6: Maintenance and Servicing
Step Action
1 Back up your data, as described in the NetCache Administration
Guide.
2 Enter the following command on the system console:
halt
Result: System activity is suspended to the disks. It might take
several minutes for system activity to cease completely.
3 Turn off the appliance power and unplug it from the power source.
4 While grounded, remove the bezel, then press the release button on
the disk drive carrier handle to unlock the drive.
5 Swing the drive carrier handle away from the appliance and slide the
drive out of the disk drive bay.
To install the replacement disk drive in the single-disk C1200 system, complete
the following steps.
Step Action
1 Make sure that the system is off and unplugged from the power
source. If it is not, complete the shutdown and power-off steps
described in
2 Align the replacement drive with the edges of the empty slot 0 drive
bay, then slide the drive all the way into the bay.
Note
You can only install a replacement disk in a single-disk system in
disk drive slot 0.
3 Close the drive carrier handle and push until it seats. Make sure that
the drive is secure by giving it a gentle tug. If the drive comes out,
reseat it and lock it into place, then replace the bezel.
"Removing a disk in a single-disk C1200" on page 70.
71