Network Appliance C1200 NetCache Service Manual page 114

Installing the
motherboard—
C2100 only
104
Step Action
7 Remove the DIMMs, as described in
page 92.
To install a motherboard, complete the following steps.
Step Action
1 Seat the new motherboard into the chassis, aligning the screw holes
in the motherboard and chassis. Secure it to the chassis with the
motherboard screws, then attach the two screws on the back of the
appliance, below the NIC ports.
2 Using two screws, reattach the system ID cover directly below the
expansion adapter ID ports.
3 Plug all power wires and the SCSI ribbon cable into the motherboard.
Caution
Make sure that you match the wires with the correct plugs on the
motherboard and have attached the ATA Flex cable retaining bracket.
4 Install the DIMMs, as described in
5 Install the chassis fans, as described in
C2100" on page 83.
6 Connect all motherboard cables to their appropriate places on the
motherboard.
7 Install the NIC and NVRAM 4 risers, as described in
expansion
8 Close the appliance, as described in
page 66.
9 Go to "Updating the motherboard
adapter" on page 98.
"Removing a DIMM" on
"Installing a DIMM" on page 93.
"Installing a chassis fan in the
"Installing an
"Closing the appliance" on
firmware" on page 105.
Replacing the motherboard