Set All Defaults/Cancel Bar Codes - Honeywell 8650 User Manual

Ring Imager Setting 4400
Intercharacter Gap Size
Macro PDF
Macro PDF Transmit/Decode Mode Symbols
Transmit Macro PDF Control Header
Escape Characters
Flush Macro PDF Buffer
Abort Macro PDF Entry
Redundancy Level (page 5-77)
Security Level (page 5-79)
Intercharacter Gap Size (page 5-80)

Set All Defaults/Cancel Bar Codes

Use the Set All Defaults bar code to return all parameters to their default values. Scanning this bar code does not affect the
mobile device's operating system, wireless client or installed software (e.g., AppLock) settings.
When the Parameter Scanning parameter is disabled, the scan engine can still scan the Set All Defaults bar code. Default value
of Parameter Scanning is Enable.
When parameters are changed, the new value replaces the standard default value in memory.
Set All Defaults
Cancel
See Pre-Configured Defaults
See Also: Reset (page 2-10)
(page 5-80)
(page 5-1) for an alphabetical listing of all default values.
Default
Normal
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Level 1
Level 1
Normal
5 - 5