Set Lengths For I 2 Of 5 (Superseded); One Discrete Length (Parameter L1); Two Discrete Lengths (Parameter L2) - Honeywell 8650 User Manual

Set Lengths for I 2 of 5 (superseded)

Note: The bar codes on this page have been replaced with newer bar codes. See Also:
L1 Default: 14
L2 Default: 14
Lengths for I 2 of 5 may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains.
See the table titled ASCII Character Equivalents

One Discrete Length (Parameter L1)

This option decodes only those codes containing a selected length. For example, when you want to scan only I 2 of 5
symbols containing 14 characters, scan the "I 2 of 5 One Discrete Length" bar code and then the "1" and "4" bar codes
using the Keypad Number Symbols
To begin setting one discrete length, scan this "I 2 of 5 One Discrete Length" bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.

Two Discrete Lengths (Parameter L2)

This option decodes only those codes containing two selected lengths. For example, when you want to scan only I 2 of
5 symbols containing 2 or 14 characters, scan the "I 2 of 5 Two Discrete Lengths" bar code and then "0", "2", "1" and "4"
bar codes using the
To begin setting two discrete lengths, scan this "I 2 of 5 Two Discrete Lengths" bar code:
Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.
4 - 70
(page 9-2).
(page 4-72).
Keypad Number Symbols (page 4-72) at the end of this section.
Set Lengths for I 2 of 5 (page 4-45).