Simple Serial Interface (Ssi) Options; Ssi Defaults; Beep On Bel; Baud Rate - Honeywell 8650 User Manual

Simple Serial Interface (SSI) Options

The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for dif-
ferent hosts. Contact
Note: Baud Rate Parameter must remain at 9600 bps at all times.

SSI Defaults

The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts.
Option

Baud Rate

Beep on < BEL >
Check Parity
Decode Data Packet Format
Host Character Time-out
Host Serial Response Time out
Intercharacter Delay
Parity
Software Handshaking
Stop Bit Select

Beep on BEL

This parameter is enabled. There is no corresponding programming bar code required.
Baud Rate
Baud rate is the number of bits of data transmitted per second. The scanners baud rate setting should match the data
rate setting of the host device. If not, data may not reach the host device or may reach it in distorted form.
Baud rate should always be set to 9600. If the baud rate is set to any other value but 9600, a transmit error will occur.
Either scan the 9600 bps bar code or reset the mobile device to factory default (or last saved good default) values.
Set this parameter by scanning this bar code.
9600 bps
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts. Contact
4 - 18
Customer Support (page 10-1) for technical help.
Customer Support (page 10-1) for technical help.
Default Value
Not Supported
Supported
Not Supported
Unpacketed
200 msec
2 sec
0
None
Enable
1