Chapter 8 - Battery Chargers; Unpacking Your Battery Charger; Introduction - Honeywell 8650 User Manual

8
Battery Chargers

Unpacking your Battery Charger

After you open the shipping carton containing the product, take the following steps:
• Check for damage during shipment. Report damage immediately to the carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.

Introduction

The Bluetooth Ring Scanner (BTRS) Module Battery Chargers are designed to simultaneously charge eight rechargeable
Lithium Ion (Li-Ion) batteries. The time required for charging is dependent upon the battery internal temperature and condition.
The Bluetooth Ring Scanner Module Single-bay charger is designed to charge one rechargeable Lithium Ion (Li-Ion) battery
pack at a time.
The battery charger should be located in an area where it:
Is well ventilated.
• Is not in high traffic areas.
• Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
• Has enough clearance to allow easy access to the power port on the back of the device.
• Is protected from rain, dust, direct sunlight or inclement weather.
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside a mobile device, if any.
This information is intended to familiarize the user with the safety and operating instructions necessary to use the Bluetooth
Ring Scanner Battery Charger (Model 8650377CHARGER, 8650378CHARGER, 8650379CHARGER, 8650380CHARGER) to
charge rechargeable lithium-ion batteries (8650376BATTERY) .
This guide should be readily available to all users and maintenance personnel using this battery charger.
Store the charger and batteries when not in use in a cool, dry, protected place.
8 - 1