Operating Instructions; Lighting Procedure; Shutdown Procedure; First Fire - Firegear KWCH-2 Owners & Installation Manual

OPERATING INSTRUCTIONS

OPERATING
INSTRUCTIONS
1. Read and understand these instructions before
operating this appliance.
2. Check to ensure there are no gas leaks.
3. Verify log placement. If the pilot cannot be
seen when lighting the unit, the logs have been
incorrectly positioned.

LIGHTING PROCEDURE

1. Remove cover, if installed.
2. Turn on gas to appliance.
3. Using a long lit match or BBQ lighter,
position ignition source anywhere on the
burner tube.
4. Turn Gas Control Knob counter clockwise
to the « ON » position - push in.
5. Once appliance is lit - hold Gas Control
Knob in for an additional 30 seconds.
6. After 30 seconds - release Gas Control
Knob.
If after 30 seconds appliance does not stay
lit:
a) Push Knob in, lightly - turn clockwise
to « OFF » position.
b) Wait 5 minutes - allow unit to cool.
c) Clear any obstructions around the
thermocouple.
d) Repeat steps 3-6.
DO NOT place hand over burner
when lighting.
30 30
SHUTDOWN
PROCEDURE
1. Shut off gas supply to appliance.
2. Allow unit to cool—reinstall cover.

FIRST FIRE

The fi rst fi re in your decorative gas appliance is
part of the paint curing process. To ensure that
the paint is properly cured, it is recommended
that you burn your decorative gas appliance for
at least one (1) hour the fi rst time you use it.
When fi rst operated, the unit will release an odour
caused by the curing of the paint, the burning off
of any oils remaining from manufacturing.
The glass windshield may require cleaning after
the unit has cooled down.
DO NOT ATTEMPT TO CLEAN THE
GLASS WHILE IT IS HOT.
Firegear Outdoors® Key West™ Series