Glass Windshield Installation - Firegear KWCH-2 Owners & Installation Manual

INSTALLATION
1. Remove metal fasteners from the corner brackets.
2. Assemble the 4 pieces of the glass surround/windshield and fasten
together with 4 corner top brackets and supplied nylon fasteners as
shown below.
3. Using a fl at screwdriver, secure 4 top corner brackets with nylon
fasteners in each corner, bracket should be fl ush with the top of glass
as shown below.
4a. After the 4 top brackets are installed - fl ip over and place on a soft
surface, to install the 4 bottom brackets.
26
OPTIONAL GLASS WINDSHIELD INSTALLATION
4b. Use supplied spacer tool to determine where the bottom bracket
should be placed and secured.
Nylon fasteners
5. Secure bottom corner brackets with nylon fasteners in each corner.
6. Flip the glass back over and place on a soft surface. The glass is now
right side up. The glass should be raised up 1/2" in bracket as shown
below.
7. Place assembled glass surround/windshield on table top - ensure glass
is centered on the table top. Once in correct position, lift up one end,
apply double sided tape that has been cut to size, to the bottom of the
brackets. Repeat process on other end. Press down fi rmly from to
secure glass surround/windshield in position. Use care not to scratch
surfaces.
Bottom Bracket
Spacer tool
Top Bracket
Insert nylon fastener
here.
Nylon fasteners
1/2"
Firegear Outdoors® Key West™ Series