Lp Hard Line Conversion (For Use In Place Of Lp Tank) - Firegear KWCH-2 Owners & Installation Manual

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one LP Hard Line Conversion Kit
Conversion Kit Contains:
Qty. Part #
1 909-265 Max 0.5 psi label
1 286-035 Regulator mounting base
1 286-036 Regulator mounting top
1 911-136 Regulator LP
1 904-978 3/8" fl ex pipe 18" length
4 904-959 #8 Philips
1 919-343 Instruction sheet
Turn off unit and allow to cool to room temperature.
1. Remove gas knob by pulling off - then remove end panel by lifting up
and off.
Firegear Outdoors® Key West™ Series
LP HARD LINE CONVERSION
(FOR USE IN PLACE OF LP TANK)
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Description
Diagram 1
Diagram 2
2. Remove panel on opposite end by lifting up and off.
3. Disconnect and remove LP tank.
Diagram 3
4. Remove 3 screws in locations shown below to remove side panel.
Note: Coffee height table requires removal of only 2 screws (no middle
screw).
Diagram 4
5. Remove LP hose from valve.
LP hose
INSTALLATION
Diagram 5
17