Conversion From Lp To Ng - Firegear KWCH-2 Owners & Installation Manual

INSTALLATION
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
Each Kit contains one NG Conversion Kit
Conversion Kit Contains:
Qty. Part #
1 904-989
1 908-529
1 909-265
1 286-035
1 911-135
1 904-978
4 904-959
1 919-342
Turn the unit off and allow to cool to room temperature.
Remove leaf cover and any media (glass etc) if installed.
Remove Table Top - see instructions in this manual.
1. Remove burner by removing 4 screws in locations shown below. If glass
crystals are installed, move the crystals out of the way to reveal screws.
Diagram 1
2. Slide burner to the left, away from the pilot orifi ce and lift out.
Diagram 2
3. Locate LP burner orifi ce.
Diagram 3
14

CONVERSION FROM LP TO NG

IF IN DOUBT DO NOT DO THIS CONVERSION !!
Description
Burner Orifi ce #23
Yellow NG Label
Max 0.5 PSI Label
Regulator Mounting Base
Regulator NG
3/8" fl ex pipe black (18" length)
Phillips screws
Instruction Sheet
4. Remove burner orifi ce with a 1/2" wrench. Use another wrench to hold on
to the elbow behind the orifi ce. Discard orifi ce.
5. Adjust aeration setting to fully closed for NG.
6. Reinstall burner.
7. Remove gas knob by pulling off - then remove end panel by lifting up
and off.
Diagram 5
Diagram 6
Diagram 7
Diagram 8
Firegear Outdoors® Key West™ Series