Firegear KWCH-2 Owners & Installation Manual page 18

INSTALLATION
Coffee table unit only
Access for
Hard line
(knockout)
Island and Cocktail table units
Location to install
regulator
6. Remove LP tank and LP hose from valve.
7. Install regulator bracket onto unit base with 2 screws. Connect fl ex
line to regulator—position regulator onto bracket.
8. Secure regulator in position with top bracket - secure with 2 screws.
Regulator
Regulator
Bracket
18
Location to install
regulator
Diagram 6
Access for
Hard line
(knockout)
Diagram 7
Diagram 8
NOTE: Top bracket to sit over top of lower bracket.
Attach supplied "MAX. 0.5 PSI" sticker to top bracket.
Top
Bracket
9. Remove connector from end of fl ex line.
10. Connect fl ex line to valve fi tting.
Diagram 11
11. Bring gas to appliance. The connector removed in previous steps
can be used on the inlet side of the regulator.
12. Check all gas connections (at valve, regulator, and LP outlet) under
normal operating pressure, for leaks, with soapy water.
NOTE: If soap bubbles, this would indicate a gas leak.
13. Check inlet and outlet pressures.
Diagram 9
Remove
Diagram 10
connector
Connect fl ex line
to valve
Firegear Outdoors® Key West™ Series