Table Top Installation - Coffee Height Unit - Firegear KWCH-2 Owners & Installation Manual

TABLE TOP INSTALLATION - COFFEE HEIGHT UNIT

Before installation,stainless steel must be handled and cleaned as per instructions noted below:
• Stainless table top must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even when
removing protective coating).
•Stainless table top will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a fi lm/
residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to the unit.
Failure to do this will result in burn stains on table top which you will be unable to remove.
Not protected by product warranty.
NOTE: These instructions apply to both the stainless steel and sunset
bronze table tops.
NOTE: Coffee table unit shown below, instructions also apply to built-in
burner.
Two brackets need to be installed before installing the Table Top.
1. Remove end panels and gas
knob, by pulling off.
2. Install Table Top bracket (on each
end) with 3 screws to unit as
shown below.
3. Reinstall end panels and gas knob.
4. Repeat Step 1 and 2 on other side.
5. Place Table Top
on Unit.
Firegear Outdoors® Key West™ Series
Stainless Steel Table Top
6. Secure table to unit from underside (on each end),
7) Place end caps over pilot and opposite end to com-
8) To remove - reverse steps 7-5.
INSTALLATION
with 4 screws in locations shown below.
plete installation.
End Caps
Final Install
21