Resetting A Zone In Alarm - GE AL-1103 User Manual

To reset a local alarm, do the following:
1. Press ENTER, ENTER (see Figure 1 ).
2. The zones causing the alarm are listed either
one at a time (Figure 6 ) or as a list
(Figure 7 ) according to system programing.
If Display Zones is enabled, then one zone
and its description will be displayed at the
RAS. Press NEXT (see Figure 1 )+ MENU*
(see Figure 1 )to see the next active zone and
its description. If Display Zones is disabled,
then a list of zone numbers will be displayed
at the RAS. Press the zone number and press
ENTER to see its description.
3. Press 0 and press ENTER to reset the local
alarm.
4. The keypad displays alarm conditions
(Figure 8 ).
5. Fix the problem, for example close the door.
Note: If your system has been programmed to remind you about alarms, it will automatically re-alarm after a preset time
unless the cause of the alarm has been fixed, no matter how many times you acknowledge the alarm. When a re-alarm
does occur, the letter preceding the zone number will not be shown.

Resetting a zone In alarm

A zone alarm occurs when:
• The LED of the area in alarm flashes red on the keypad.
• The sirens are active (if programmed).
When an alarm occurs, the display There Are No Alarms In This Area or the custom LCD display
disappears from the top line. Instead the display will show:
To reset a zone alarm, do the following:
1. Enter your PIN code.
2. Press OFF (see Figure 1 ). The keypad displays the opening screen.
Figure 6. Zones causing alarm one at a time
Local Alarm On A4, Rear Door
NEXT or ENTER
Figure 7. RAS display indicating no alarms
Local Alarm On A4, A5, A9, NEXT
Zone No:
Note: The system installer can program a custom LCD
message. The default is time and date, if the user
does not want the time and date to be visible,
disable the default message. After disabling it the
LCD displays the message shown in Figure 8 .
Figure 8. Zones causing alarm as a list
There Are No Alarms In This Area
Code:
Alarm On ...
Code:
19