View Zone Status; Setting The Keypad Tone; View Alarm Memory; Test Function - GE LCD Keypad User Manual

VIEW ZONE STATUS

1. Press [r] [•]. The LCD Screen will display the zone status.
2. Use the up and down scroll keys to browse through the descriptions. The LCD
Screen will display the list of all zones in sequential order by zone number.
3. Press [#] to exit.

SETTING THE KEYPAD TONE

1. Press [r] [0]. Keypad is now in the "Adjust Tone" mode.
2. Press [•] to adjust the keypad sounder to
higher tones.
3. Press [–] to adjust the keypad sounder to
lower tones.
4. When the desired tone is reached, press [#] to set this tone and exit from the
"Adjust Tone" mode.

VIEW ALARM MEMORY

1. Press [r] [3] to display the zone(s) on the keypad that created the last alarm.
2. The LCD Screen will display the zone
description for those zones.
3. Press [#] to exit the alarm memory.
TEST FUNCTION (Optional, if programmed)
If programmed, this function will perform a battery test, communicator test, and/or
a siren test. No alarms will be sent, and no reports will be sent unless a
communicator test is performed, in which case a test signal will be sent.
1. Press [r] [4] [4]. The test will be performed as programmed.
2. If the siren test is performed, enter a user code to silence the siren.
10
Raise tone
Lower tone
l
A arm Memory 1
ZONE 1
LCD Keypad
º
º