View Zone Status; Setting The Keypad Tone; View Alarm Memory; Test Function - GE NetworX NX-148E User Manual

VIEW ZONE STATUS

Step 1 Press r • . The LCD Screen will display the zone status.
Step 2 Use the up and down scroll keys to browse through the descriptions. The
LCD Screen will display the list of all zones in sequential order by zone
number.
Step 3 Press [#] to exit this function.

SETTING THE KEYPAD TONE

Step 1 Press r
0 . Keypad is now in the "Adjust Tone" mode.
Step 2 Press the • up scroll key located
on the right side of the display to
adjust the keypad sounder to higher
tones.
Step 3 Press the – down scroll key to adjust the keypad sounder to lower tones.
Step 4 When the desired tone is reached, press #
from the "Adjust Tone" mode.

VIEW ALARM MEMORY

Step 1 Press r
3 to display the zone(s) on the keypad that created the last
alarm.
Step 2 The LCD Screen will display the zone
description for those zones.
Step 3 Press [#] to exit the alarm memory.
TEST FUNCTION (Optional, if programmed)
If programmed, this function will perform a battery test, communicator test, and/or
a siren test. No alarms will be sent, and no reports will be sent unless a
communicator test is performed, in which case a test signal will be sent.
Step 1 Press r
4
Step 2 If the siren test is performed, enter a user code to silence the siren.
NX-148E LCD Keypad
Raise tone
Lower tone
l
A arm Memory 1
ZONE 1
4 . The test will be performed as programmed.
º
º
to set this tone and exit
11