System Menu Option 4, Bypassed Zones - GE AL-1103 User Manual

Table 13 lists the display options.
Table 13. All zones in alarms menu options
Option
Display the complete zone name.
Update the zone list and display the next zone on the list (if any).
Exit menu 3.
Exit the menu option and return to the original display.
Note: Tamper alarms are identified with a "T" preceding the zone number.

System menu option 4, Bypassed zones

Use this menu to list all bypassed zones. You bypass a zone to exclude it from the security system when it is
broken or faulty. This keeps it from causing an alarm. Use this menu to determine which zones are not
operating properly and need attention.
List all bypassed zones
To list all bypassed zones, do the following:
1. Press MENU* (Figure 1), enter your user
PIN code, and press ENTER (Figure 1).
2. Enter 4 (for menu 4) and press ENTER.
3. The display that appears depends on the
status of the zones.
3a. If no zones are bypassed the display
shows no bypassed zones (Figure 19).
3b. If zones are bypassed, the display will
shows either a list of zones or one at a
time (Figure 20) or as a list of zone
numbers (Figure 21).
4. Press ENTER to exit menu 4.
Action
Enter the zone number and press ENTER.
Press ON/NEXT.
Press ENTER.
Press CLEAR.
Figure 19. No zones in alarm
No Bypassed Zones
Press ENTER
Figure 20. Zones in alarm listed one at a time
Bypass On 2, Front Door Contact
NEXT or ENTER
Figure 21. Zones in alarm listed by number
Bypass On 1, 3, T4, 5
Zone No:
Chapter 2
Alliance system menu
29