The Leds - GE AL-1103 User Manual

4 Alliance System
User Manual
In some instances there can be insufficient space to display all the text being presented (e.g. a list of areas in the
building).
• If a complete list is displayed on line 1, there is a full stop "." at the end of the list.
• If the list is incomplete, the text will continue to scroll across the LCD. To jump to the beginning, press
ON/NEXT (see Figure 1 ) on the keypad. The display will update the information at the same time.
• If only part of a name or location is shown, it can be moved left by entering the applicable number
preceding the text, and then pressing ENTER (see Figure 1 ).
• Your system might display a custom message instead of the one shown above if it has been
programmed to do so:

The LEDs

The LEDs on the keypad, together with the information shown on the display, allow you to determine the
system status at a glance.
Area LEDs
One area LED in each of the possible security areas, indicates the status for that area. Table 1 describes the area
LEDs for the AL-1103 keypad.
Table 1. Area LED description AL-1103 keypad
LED Function
On
Off
Blinking
When the AL-111x Remote Arming Stations (RAS) cover is opened or removed and the system is armed, 16
area LEDs are visible (see Figure 1 ). Each LED represents an area, and the indications are as shown in
Table 2. Record the area names on a label inside the cover.
Table 2. Area LED description AL-111x keypad
Red
Red blinking
Green
Off
Description
The area is unoccupied and armed.
The area is occupied and the security system has been set to allow normal access.
An alarm has occurred in the area while the area was disarmed (LED flashes slow) or armed (LED flashes
fast).
Area is unoccupied and armed.
A fault is detected, or when an alarm occurs while disarmed (LED blinks slowly) or armed (LED blinks quickly).
Area is disarmed and ready to arm.
The corresponding area is disarmed, but not ready to arm
Welcome to the Alliance System