Typical Mdf Scenarios; Figure 5-3 Installation Scenario A - ZyXEL Communications IES-2500 User Manual

You can also attach RJ-11 connectors to the Telco-50 cable and connect directly to a DSL modem(s) or patch
panel. This chapter discusses connections using MDFs.

5.6 Typical MDF Scenarios

This section describes typical installation scenarios.
5.6.1 Installation Scenario A
You want to install the IES-2500 in an environment where there are no previously installed MDFs. There is no
phone service and you want to install the IES-2500 for data-access only. No connection from the Telco-50 CO
connector is necessary.
You may connect using an MDF or attach RJ-11 connectors to the non-IES-2500 end of the Telco-50 cable and
then connect to DSL modems directly.
Procedure to Connect to an MDF
Connect the Telco-50 connector end of the cable to the Telco-50 connector labeled USER on the
Step 1.
splitter chassis rear panel.
Connect the wiring on the other end of the Telco-50 cable to the upper ports of the MDF using a
Step 2.
punch-down tool.
Connect the telephone wiring from each end-user's DSL modem to the lower ports of the MDF.
Step 3.
MDF Connections

Figure 5-3 Installation Scenario A

IES-2500 User's Guide
5-3