Table of Contents
Advertisement
Default button
Save and Load
buttons
To restore the factory default settings for your card set, click the
button. If you have more than one card in your card set, you can choose
which settings you want to restore.
The
Save
button lets you save your configuration settings to a .cfg file. To
apply those settings, click the
select which settings you want from the file, such as
click
.
Open
Note
Once you've configured a card set, it's a good idea to save your
settings to a .cfg file for backup purposes.
Making permanent or temporary settings
Unless you want your card configuration settings to be effective only for
the current work session, make sure you select
clear this option, any changes you make will be cleared the next time you
start your system. This lets you assign temporary settings to DigiDesktop.
For example, if
Permanent Settings
card configuration changes you've made will be saved only until you
reboot your computer. Once you reboot, your settings will be returned to
their previous state.
Changing default proc amp and video input settings
If you'd like your default proc amp and video input settings for
DigiDesktop to be restored each time you start the DigiSuite Configuration
program, select
Always Restore Default Settings
temporary changes you made to these settings (either in the DigiSuite
Configuration program or another program) to be cleared the next time you
start the DigiSuite Configuration program.
Alternately, if you don't select
you start the DigiSuite Configuration program you'll be notified if the proc
amp or video input settings were changed during the current work session.
You can then indicate whether or not you want to use those settings as your
new defaults.
button and select your .cfg file. Then
Load
Permanent Settings
isn't selected when you click
Always Restore Default Settings
Using the DigiSuite Configuration program
Default
, and
DigiDesktop
. If you
, the
OK
. This causes any
, when
25
Advertisement
Table of Contents
