Table of Contents
Advertisement
Installing the Matrox display driver and PowerDesk
Set Administration permission level
In order to install or remove DigiDesktop software, you must be
configured as an Administrator in Windows NT User Manager. For details
about the User Manager program, consult the appropriate Microsoft
documentation.
Check amount of free disk space
To install all the software for DigiDesktop, you'll need about 12 MB of
free space on your hard drive. If you don't have enough free space, delete
some files before continuing with the software installation.
You need to install the Matrox display driver and PowerDesk for
DigiDesktop before installing DigiUtils.
Note
DigiDesktop is compatible with the Matrox Millennium and
Mystique cards. Whenever you see these names or MGA in the installation
process, you can assume that this applies to your DigiDesktop card as well.
1
Insert the DigiSuite CD-ROM in your CD-ROM drive.
2
Choose
Start | Run
3
In the resulting dialog box, type e:\matroxdisplaydriver\nt40\setup
(where e: represents your CD-ROM drive), and click
4
Select the language you want to use, then click
5
Choose an installation type:
–
To install the complete Matrox PowerDesk (recommended), click
.
Typical
–
To customize the PowerDesk installation, click
If you click
Custom
folder and what PowerDesk options you want to install.
After you choose, the setup program automatically installs the software.
After this is done, click
You can now configure your monitor and DigiDesktop display as
explained in the following sections.
Installing the Matrox display driver and PowerDesk
.
, the setup program prompts you for a destination
to restart your computer.
Finish
OK
.
.
Next
.
Custom
19
Advertisement
Table of Contents
