Position Of The Pick-Up Guide Plate Cam (Multifeeder Assembly); Routing The Timing Belt (Multifeeder Assembly) - Canon NP6330 Service Manual

7

Position of the Pick-Up Guide Plate Cam (multifeeder assembly)

Adjust the engagement of the 26T gear 1 and 26T gear 2 so that the paper guide
plate and the paper guide plate cam are as shown in Figure 11-243 when the solenoid
plate is in contact with the claw of the control ring.
8

Routing the Timing Belt (multifeeder assembly)

Butt the rack plate of the multifeeder against section A (open state).
Move the slide volume in the direction of B, and attach the timing belt to the pulley.
COPYRIGHT © 1997 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
26T gear 1
Paper guide plate

   
Paper guide plate
cam
26T gear 2
Figure 11-243
Timing belt
Pulley
Rack plate
B
Slide volume
Figure 11-244
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
Control ring
Claw
Solenoid plate
Section A
Pulley
11-37