Canon NP6330 Service Manual page 136

4) Remove the lid
5) Free a length of about 40 mm of charging wire from the reel (0.06-mm dia.), and form
a loop with a diameter of about 2 mm at the end.
Reference:
To form a loop, wind the charging wire around a hex key once, and twist the hex
key four to five times; then, twist the charging wire.
6) Cut the twisted end of the charging wire (excess) to 1 mm or less with a nipper.
COPYRIGHT © 1997 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
(both front and rear).
Figure 4-329
Figure 4-330
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE FORMATION SYSTEM
less than 1mm
corona wire
4-39