Adjusting The Book Erasing - Canon NP6330 Service Manual

10 Adjusting the Book Erasing Width [3] No. 326
Adjust the width that runs in the middle of an original in book erase mode.
The Length of χ in Figure 11-213 may be changed.
This mode does not allow changing the left/right edge of a book original.
Making adjustment
1) Start [3] in service mode, and select No. 326 using the keypad.
• The indicator indicates '326'.
2) Press the OK key.
• The indicator indicates the stored setting.
3) Using the keypad or the Zoom keys, change the setting.
• The indicator flashes the setting.
• To enter a negative setting, press the % key.
4) Press the OK key.
• The new setting is stored.
• The indicator stops flashing and remains on.
• A press on the Copy Start key starts copying.
5) To change settings in succession, repeat steps 3) and 4).
6) Press the Clear key to return to item selection.
The settings and the book erasing width have the following relationship.
• For each '1', the frame erasing width changes by about 1 mm.
• A higher setting increases the frame erasing width.
COPYRIGHT © 1997 CANON INC.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Figure 11-213
CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 11 TROUBLESHOOTING
Book original
χ
11-21