Preparing for the Heaters
Changing the Temperature Settings for the Heaters
Set the heater temperature.
Depending on the media and the profile to use, set the heater temperature.
• It may take several minutes to tens of minutes for the set temperature to be reached, depending on the ambient
temperature.
• You can change the temperature set here also in [HEATER] of the [SETUP] menu. (
1
Press the
2
Press the
3
Press
each heater.
Heater selecting
Temperature setting : Set with
• The heater starts to get hot.(The [HEAT] lamp lights in orange.)
• When the heater temperature reaches the set temperature, the
[HEAT] lamp goes off and the [CONSTANT] lamp lights in green.
4
Press the
• The Heater temperature is controllable at the RIP side if the RIP in use has a function controllable.
(For the setting procedures, refer to the instruction manual of the RIP in use.)
• Use this machine under 20 to 30°C. The temperature may not reach the set value due to the
environmental temperature condition.
Checking the Heater Temperature
1
Press the
• The current heater temperature is displayed.
2
Press the
• The screen returns to LOCAL.
2-28
key.
key.
to set the temperature of
: Select with
key to end the setting.
key.
key at the end of confirmation.
P.3-4)
PRE
PR T
POS T
3 5 ° C
4 0 ° C
5 0 ° C
Heater temperature
confirming display
Heater temperature set in
this machine
OF F
OF F
OF F
2 3 ° C
2 3 ° C
2 3 ° C )
(
Current heater temperature
The settable temperature of
PRE and PRT: 20 to 60°C
The settable temperature
of POST: 20 to 70°C
4 0 ° C
4 0 ° C
5 0 ° C
2 3 ° C
2 3 ° C
2 3 ° C )
(
PRE
PR T
POS T
3 5 ° C
4 0 ° C
5 0 ° C