Table of Contents
Advertisement
14
At the back, lift the tension-bar down to the
stopper slowly to tighten the media.
• Unlock the tension-bar, and then lift it down.
15
Push down the clamp lever.
16
Adjust the position of the tension-bar with the switches on the left of the feeding
device.
(1) Set the switches to the take-up direction of the media.
(2) Turn the left switch to [MANUAL].
• The tension-bar is lifted, reeling the media. At this time, when the tension bar does not move
upward even if the media is fed, change the switch.
(3) When the tension-bar arm becomes parallel to the floor, turn the left switch to [AUTO] to stop the
tension-bar.
(4) Turn the switch to the feeding direction of the media.
17
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
• If the media gets to the right or the left too much,
the next warning is displayed to inform you of it
after media detection. By referring to the media
setting position nameplate attached with the main
body, reset the media.
Setting a Media
Tension bar
Media press
ERROR 5 1 6
MED I A SE T POS I T I ON R
ERROR 5 1 6
MED I A SE T POS I T I ON L
Rock
1
2
4
5
6
2-15
Advertisement
Table of Contents
